Trimming The Motor - Torqeedo Cruise 10.0R TorqLink Originalbetriebsanleitung

Startup
1 2
8 2
Fig. 42: Schematic arrangement of a TorqLink network with the 1949-1952 accelerator lever
1 Cruise 10.0 R (terminating resistor)
2 Charger unit
3
Power 48-5000
4 1949-1952 accelerator lever
A DVIC E
The branch lines must not be sub-divided or extended.
3 4
3 7 6
5 Terminator Single
6 ON/OFF switch
7
Branch line
8 Backbone
5.5

Trimming the motor

5
Fig. 43: Securing cotter pin for trim rod
1 Securing cotter pin
Install the tilt switch for trimming the motor as follows:
1. Drill a suitable hole into the console.
For this, align to the reverse side of the tilt switch.
2. Locate the data cable in the position provided on the motor.
3. Attach the tilt switch in the cockpit.
The tilting mechanism allows the motor to be tilted.
EN DE
1
page 79 / 113