Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. SAFETY INFORMATIONS
2.1 SAFETY SYMBOLS
For your safety, please pay attention to the following symbol as marked on the machine:
ENG
This label warns that only qualified service personnel can access this position and the
operator must disconnect the power before carrying out any cleaning or servicing.
2.2 WORKING SAFETY INFORMATION
The machine must only be used by personnel suitably trained for the purpose and who have
been trained in the contents of this publication.
TO ENSURE SAFE WORK, COMPLY WITH THE FOLLOWING INSTRUCTIONS:
1.
Install the machine in compliance with workplace safe work requirements.
2.
Don't place the machine near a source of heat and this machine must not be used in a
place where the surrounding environment may have a potential risk of explosion.
3.
Use the machine with great care and never be distracted.
4.
Do not wear loose fitting clothing or clothing with wide or open sleeves.
5.
Do not remove, cover or modify the identification plates placed on the machine body.
6.
Do not use the machine as a working surface or area and do not place any objects on it
that are not required for normal working operations.
7.
Do not use the machine with temporary electrical connections or non-insulated cables.
8.
Periodically check the state of the power cable and the cable clamp on the machine
body, have it replaced as soon as is necessary by qualified personnel.
9.
Stop the machine immediately as soon as there is any defective or abnormal operation, a
breakage, any incorrect movements, or unusual noises.
10.
Before cleaning or carrying out maintenance, disconnect the machine from the
electricity mains.
11.
Use protective working gloves for cleaning and maintenance.
12.
For all extraordinary maintenance, consult the manufacturer or qualified and
authorised personnel.
13.
Do not use water jets or spray to clean the machine.
14.
When sharp accessories are manipulated, use cut-resistant gloves.
3. INSTALLATION
3.1 GENERAL INSTALLATION REQUIREMENTS
NOTE:
It is most important that this machine is installed correctly and that the operation
is correct before use. Installation shall comply with local electrical, fire, health
and safety requirements.
This machine is designed to provide years of satisfactory service. Correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
3.2 INSTALLATION
This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room.
Installations must be carried out by qualified service persons only. Failure to install equipment
to relevant codes and manufacturer's specifications in this section will void the warranty.
4
Werbung
Inhaltsverzeichnis
