Production - Strack PowerMax SN5650-PMU-0330 Bedienungsanleitung

PowerMax cam unit SN5650-PMU-0330 — SN5650-PMU-1200

8. Production

During the production no particular precautionary measures have to be taken, which exceed the valid
operating safety regulations paragraph 3.
All data
without guarantee.

10
STRACK NORMA GmbH & Co. KG · Königsberger Str. 11 · D-58511 Lüdenscheid · Tel +49 2351 8701-0 · www.strack.de
Attention:
If attachments are removed during the assembly process, they must be secured again with
Loctite 242.
Notes on tightening torques:
Screws
DIN EN ISO 4762-10.9
Tightening torque [Nm]
Advice:
Please secure that the STRACK cams especially the gas springs are not dipped in fluid.
If you are using for example aggressive drawing oils during the production, make a controlled
drain for them (drainage borings, cutouts and so on), so that the fluids are directed away from
the gas springs.
Thereby seal damages are avoided.
Tip:
Control the nitrogen pressure of the gas springs in regular intervals, to detect changes in the
pressure level in time. During maintenance works you have to consider a correct return of the
cam slide.
Advice:
The cam units are equipped with low-maintenance slide elements out of bronze with solid
lubricant. In normal case lubrication is not necessary.
A lubrication may only be effected in case of need with the following lubricants:
Company Oils
AGIP Potra ATF
BP Autran DX II
ESSO ATF Suffix A
ESSO ATF - D
OMV ATF Serie
SHELL Donax TM
SHELL Donax TF
I
Operating instructions -- PowerMax cam unit PMU
M6 M8 M10
14 33 65
Greases
Agip GR MU 2
Energrease
Nebula EP 2
Beacon EP 2
OMV signum CX 2
Retinax LX
PowerMax
M12 M16 M20
121 302 590