Preparation Of Tool And Press; Shouldering - Strack PowerMax SN5650-PMU-0330 Bedienungsanleitung

PowerMax
I
Operating instructions -- PowerMax cam unit PMU
PowerMax cam unit SN5650-PMU-0330 — SN5650-PMU-1200

6. Preparation of tool and press

Tool, press and peripheral devices have to be suited, prepared and adapted according to the indications
of STRACK NORMA for the utilisation of the PowerMax cam unit.
Drain off fluid (for example water or drawing compounds) well-directed by drainage. You have to take
care that punching wastes don't fall in or on the cam guidance.
Cam slide and guidances can seize. Parts falling down can damage the guidances, hereby possibly the
running life of the cam reduces. If there is a failure, the cam slide can't be placed back in the initial
position.

7. Shouldering

The force distribution of the individual forces in the cams depends on the right shouldering in the tool
and the cam angle.
If the heights h1 and h2 (see the picture below) reduce in the tool, the forces of the shouldering can't
be completely absorbed.
You will find detailed information in the catalogue indications concerning your cam in the internet under
www.strack.de
FP
Fh1
h1
FA
FS
h2
Fh2
α
FW
9
STRACK NORMA GmbH & Co. KG · Königsberger Str. 11 · D-58511 Lüdenscheid · Tel +49 2351 8701-0 · www.strack.de