Use In Explosive Areas; Description; Operation - SATA SATAjet 1000 H RP Betriebsanleitung

Operating Instructions SATAjet 1000 K (RP / HVLP) / H (RP)
EN

6.4. Use In Explosive Areas

The spray gun is permitted for use / storage in explosion hazard areas of
ex-zone 1 and 2. The product labelling must be adhered to.
• The following applications and operations lead to the loss
of the explosion protection and are, therefore, prohibited:
• Use of the spray gun in explosive areas belonging to ex-zone 0!
• Do not use solvents and cleaning agents based on halogenised
hydrocarbons! Chemical reaction which may occur when using these
substances may be explosive!
7.

Description

The compressed air required for spraying is supplied at the compressed
air connection. Pull the trigger to the first pressure point to activate the
pre-air control. Continue pulling the trigger to pull the paint needle out of
the fluid tip: the material flows without pressure out of the fluid tip and is
atomised by the compressed air flowing out of the air cap.
8.

Operation

Risk of injury from bursting compressed air hose
If an unsuitable compressed air hose is use, it can be damaged by too
much pressure and explode.
→ Use only solvent-resistant, antistatic and technically flawless tubes
for compressed air with a permanent pressure resistance of at least
10 bar, a bleeder resistance of < 1 MOhm and a min. interior diameter of
9 mm (see chapter 14).
132
Warning! Risk of explosion!
Warning!