Personal Protection Equipment - SATA SATAjet 1000 H RP Betriebsanleitung

Operating Instructions SATAjet 1000 K (RP / HVLP) / H (RP)
• Put spray gun immediately out of operation when damaged, discon-
nect it from the compressed air circuit!
• Never manipulate or technically modify the spray gun!
• Use original SATA spare parts and accessories only!
• Disassemble and install components very carefully! Exclusively use
included special tools!
• Exclusively use spray gun washing machines recommended by SATA!
Please observe the operating instructions!
• Never spray materials containing acid, lye or benzine!
• Alyways keep the spray gun away from ignition sources, such as open
fire, burning cigarettes or non-explosion-proof electronic devices!
• When working with the spray gun, always limit solvents, paints or
other coating media to the quantities which are required for the paint
job! Excessive material must be returned to the designated storage
areas afterwards!

6.3. Personal Protection Equipment

• When using, cleaning or maintaining the spray gun, always wear
approved breathing and eye protection equipment as well as suitable
protective gloves, overalls and safety boots!
• When using the spray gun, noise levels of 85 dB(A) may be exceed-
ed. Wear suitable hearing protection!
• Hazard from hot surfaces
When processing hot materials (temperature exceeding 43 °C; 109.4
°F) always wear corresponding protective clothing.
The painter is not exposed to vibrations while using the spray gun. Repul-
sive forces are minimal.
Warning! Attention!
Warning!
EN
131