SATA SATAjet 1000 H RP Betriebsanleitung Seite 134

Operating Instructions SATAjet 1000 K (RP / HVLP) / H (RP)
EN
■ For SATAjet 1000 H: mount suction cup [2-9] with material sieve [2-
10] and drip-stop [2-11]. Mount clasp [1-13] so that it points towards
the nozzle.
■ Connect compressed air hose [2-8].
Adjust gun inner pressure
Notice!
The air micrometer [1-4] must be fully opened (vertical position) in the
settings [3-2], [3-3] and [3-4].
Notice!
The most precise way to adjust the gun inner pressure is with SATA
adam 2 [3-1].
Notice!
If the gun input pressure does not reach the necessary level, increase
the pressure in the compressed air circuit.
Too much input pressure results in high trigger forces.
■ Pull trigger guard [1-16] right back.
■ Adjust the gun input pressure to one of the following settings [3-1],
[3-2], [3-3] to [3-4]. Note the maximum gun inlet pressure (see chap-
ter 2).
■ Bring the trigger guard to the starting position.
Adjust the material flow
Notice!
When painting, only use as much material as is required for the specific
procedure.
When painting, maintain the necessary spray distance. After painting,
store or dispose of the material correctly.
Notice!
Wear at the fluid tip and paint needle is lowest when the material flow
control is wide open. Select fluid tip size according to the material and
working speed.
Fully variable adjustment of the material flow and thus the needle stroke
134