SATA SATAjet 1000 H RP Betriebsanleitung Seite 142

Operating Instructions SATAjet 1000 K (RP / HVLP) / H (RP)
EN
Malfunction
Air bubbles in suction
cup.
Spray pattern too
small, slanted,
one-sided or split.
Round / flat fan control
not working – control
can be regulated.
Round / flat fan control
cannot be regulated.
142
Cause
Loose air cap.
Gap between air cap
and fluid tip (air circuit)
is clogged.
Nozzle set is soiled.
Damaged nozzle set.
Not enough material in
suction cup.
Defective paint needle
seal.
Air cap holes clogged
with paint.
Damaged fluid tip
(fluid tip aperture).
Air distribution ring not
correctly positioned
(pin not in hole) or
damaged.
Not enough material in
suction cup.
Round / flat fan control
has been turned coun-
terclockwise over the
limit; spindle loose in
gun thread.
Corrective Action
Tighten the air cap
hand-tight.
Clean air circuit. Heed
cleaning instructions
(see chapter 10).
Clean nozzle set. Heed
cleaning instructions
(see chapter 10).
Replace nozzle set (see
chapter 9.1).
Fill suction cup (see
chapter 8.2).
Replace paint needle
seal (see chapter 9.3).
Clean air cap. Heed
cleaning instructions
(see chapter 10).
Check fluid tip for dam-
age and replace nozzle
set if necessary (see
chapter 9.1).
Replace air distribution
ring (see chapter 9.2).
Fill suction cup (see
chapter 8.2).
Unscrew round / flat
fan control using the
universal spanner and
make it work again or
replace it completely
(see chapter 9.6).