General Instructions - Spartherm Premium V-FD-87h Aufbauanleitung

1. GENERAL INSTRUCTIONS

These installation instructions comply with the provisions outlined in DIN
EN 13229 "Solid-fuel fireplaces".
All national and regional regulations, standards and norms, methods of
installation and material specifications must be observed. Naturally, all
our fireplace inserts are subject to our own quality criteria, from incoming
goods inspection to the approval before shipping.
Small children, elderly or infirm persons:
As is the case with all heating devices, it is expedient that you attach a
protective fixture for these groups of persons, as the view pane and the
cladding parts of the fireplace can become extremely hot!
Danger of burn injuries!
Never leave these groups of persons unattended near the fireplace insert
when a fire is burning or has just been extinguished! Please ensure that
persons belonging to these groups are made aware of the dangers.
No combustible objects, materials or substances should be placed on or
near the free surfaces of the fireplace system. Do not attempt to dry out
clothing on the hot tiles of the fireplace system. When drying clothes, use
a proper drying stand or clothes' horse and ensure it is placed outside the
area of direct radiant heat!
The sur faces of your fireplace system such as the operating handles,
doors, viewing glass, etc. are getting hot by energy released during the
combustion process. Do not attempt to touch these components without
adequate protection (i.e. heat-resistant gloves).
The fireplace insert must never be modified! In particular, never install
any components into the combustion chamber, combustion passages or
the gas flue that have not been approved by SPARTHERM. Your fireplace
warranty will be rendered invalid by any fireplace modification carried out
using components not approved by SPARTHERM.
You may find that extractor hoods, ventilation equipment, etc., installed in
the same room (or linked space) as your fireplace or stove, have a negative
effect on the fireplace insert (such as the release of smoke into the room).
These devices should not be used at the same time as your fireplace or
stove, without first ensuring that the necessary room heating system pre-
cautions have been taken.
When using more than one fireplace in a single room or linked space ,
ensure that sufficient air is available for complete combustion!
This is an intermittent appliance, so longer burn times are achieved by
reloading every 45 minutes. It is not allowed to achieve longer burn times
by reducing the combustion air and thereby smothering the fire.
According to the type of fireplace inserts used low-pressure values of more
than 20-25Pa can have an impact on the correct use of the fireplace insert.
Those values may lead to stains on the glass or create noise.
Transport damage: immediately on arrival, please check the goods deliv-
ered (visual inspection). Make a note of any damage on your delivery docu-
ment. Inform your stove or fireplace fitter of the damage before the instal-
lation work begins. When installing the casing of your fireplace insert, take
care to protect the viewing glass from damage or soiling.
The technical data of your fireplace insert can be found from page 25.
GB 4