Connecting The Electrical Power To The Generator - Dometic POWER & CONTROL TEC29 EV Montageanleitung

Connecting the electrical power to the generator

➤ Secure the tank, see fig. d, page 8 and chapter "Connecting the float" on
page 31.
9.7 Mounting the remote control
Please observe the following instructions for the installation location:
• Observe the length of the extension cable from the remote control to the gener-
ator.
➤ Drill the holes as shown in fig. d, page 8.
➤ Insert the plug into the remote control.
➤ Screw on the remote control.
10 Connecting the electrical power to the
generator
D
DANGER! Danger of electrocution
Make sure there is no voltage at electrically operated components
before carrying out work on them!
I
NOTE
Observe the applicable guidelines in the country of the consumer.
10.1 Important notes on the electrical connection
• Only a qualified electrician should connect the generator to the electrical power.
• Check that the voltage specification on the type plate is the same as that of the
power supply.
• Any electric connection has to be made with flexible wiring.
• Do not lay the 230 Vw mains cable and the 12 Vg cable together in the same
cable duct.
• Do not lay cables which are loose or bent next to electrically conductive material
(metal).
• Connect the generator to a power circuit which can supply the necessary current
(see chapter "Technical data" on page 33).
26
TEC29 EV
EN