Handling Electrical Cables; Target Group For This Manual - Dometic POWER & CONTROL TEC29 EV Montageanleitung

TEC29 EV
!
CAUTION!
• Fire hazards
Do not install the generator in a box or room without any openings,
but in well-ventilated spaces instead.
• Only operate the generator if you are certain that the housing and the
cables are undamaged.
• Install the generator on a stable surface.
• Do not tilt the generator more than 20° from the vertical position.
A
NOTICE!
• Only use the device as intended.
• The generator is not suitable for use in water vessels.
• Do not make any alterations or conversions to the device.
• If a welding operation has be to done on the vehicle disconnect all
generator cables, otherwise the electronics may be damaged.
2.2

Handling electrical cables

!
WARNING!
• The electrical power supply may only be connected by a qualified
electrician (e.g. according to VDE 0100, Part 721 in Germany).
!
CAUTION!
• Attach and lay the cables so that they cannot be tripped over or dam-
aged.
A
NOTICE!
• Use cable ducts to lay cables through walls with sharp edges.
• Do not lay loose or bent cables next to electrically conductive materi-
als (metal).
• Do not pull on the cables.
3

Target group for this manual

The instructions in this manual are intended for qualified personnel at workshops
who are familiar with the guidelines and safety precautions to be applied.
EN
Target group for this manual
19