Additional Information; Troubleshooting - ABS s.cape Bedienungsanleitung

13. ADDITIONAL INFORMATION

13.1 TROUBLESHOOTING

MALFUNCTION
I pulled the activation
handle without the
cartridge being
installed
Activation handle
does not attach
TROUBLESHOOTING
– the undamped explosion
pressure will damage the
puncture unit and render it
unsafe and unusable. It
must be checked and
replaced.
– Direct all queries to your
respective service center.
– Put a drop of ABS oil into
the coupler. Push up
oupler, attach and remove
handle several times until
the coupler is functioning
properly.
– If this doesn't work the
system has to be sent to
your respective service
center.
– Do not try to attach the
handle with force.
– If you are out in the field
and you have no ABS oil
with you, push the coupler
up, attach the handle and
then push the coupler
down.
MALFUNCTION
The charged activation
handle does not come off
The airbags are difficult
to remove from the
compartments and are
hard to inflate
TROUBLESHOOTING
– You must leave the full
cartridge in place.
– Gently push the coupler
upwards, wiggle the handle
from side to side and care-
fully try pulling it down.
– In addition apply a drop of
ABS oil to the handle and
turn it to increase lubri-
cation.
– If this doesn't work the
system has to be sent in for
service.
– Were the airbags folded
properly?
– Did the weight of the
cartridge match the filled
weight?
– If you answered both with
yes you have to send the
airbag in for service.
– If you are unsure about
either one of these points,
perform a practice acti-
vation.
– If the problem persists
send the ABS-System in for
service.
English 53