Herunterladen Inhalt Inhalt Diese Seite drucken

Customer Service; Components; Airbags; Suction And Release Valve - ABS s.cape Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

You can find all the key information at
com/en/avalanche-accident/
the ABS Avalanche Airbag in right away we recommend
to check the following:
– check the airbags visually for punctures
– check the airbag fastening straps for tears
– check the shoulder, waist and chest straps as
well as the seems for tears
– check all buckles (adjustment buckles at the
shoulder straps, waist and chest strap)
– check buckles as well as leg straps for tears
and deformation
Send your ABS Avalanche Airbag System to your local
Service Center for inspection.

7.3 CUSTOMER SERVICE

After three seasons the manufacturer recommends a
general inspection. The ABS Avalanche Airbag inclu-
ding cartridge and activation handle has to be sent
to your respective service center. The ABS customer
service will charge for this inspection. The customer
service includes a much more extensive inspection
of all ABS parts than the practice activation or self
check.
The appropriate ABS customer service for each of the
countries is listed on our web page
com
under Company/Contact.
50
English
www.abs-airbag.
If you are unable to send
www.abs-airbag.

8. COMPONENTS

8.1 AIRBAGS

Each of the two airbags has a volume of 85 liters when
inflated. They are inflated simultaneously but have
separate closure and suction valves. If one of the air-
bags is damaged the other one will remain inflated for
a sufficient amount of time. The inner pressure equals
approx. 0.1 bar.

8.2 SUCTION AND RELEASE VALVE

This combination part is attached directly to the
airbag. The button for the release valve is located in
the middle of the black suction and release unit. It
is protected from unwanted pressure by a red plastic
cover. The net cover over the suction and release valve
prevents snow entering the airbag when it is being
filled. Damaged nets can be replaced at any time.

8.3 PUNCTURE UNIT

The puncture unit, into which the cartridge is screwed,
is housed at the top of the backpack. Make absolu-
tely sure that it stays clean and that no objects can
damage it. Therefore always close the cover. A screwed
in cartridge can be unscrewed from the puncture unit
at any time. Only the pull on the attached handle will
activate the cartridge. We generally recommend to
always leaving the cartridge attached.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis