Ptz Camera Setting - Avtech avc792pv Bedienungsanleitung

6)

5.6 PTZ Camera Setting

Right-click to display the main menu, and select "ADVANCED CONFIG"  "DEVICES".
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
NOTIFY
1)
2)
Note: To know the default ID of the PTZ camera, please refer to its user manual.
3)
4)
Note: To know the default baud rate of the PTZ camera, please refer to its user
Downloaded from www.Manualslib.com
AREA
Click "EDIT" to set the motion detection area.
There are 16 × 12 grids per camera for all channels. Pink blocks represent the area
that is not being detected while the transparent blocks are the area under
detection.
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 
DEVICE
ID
PROTOCOL
RATE
EXIT
DEVICE
For the PTZ camera, select "PTZ".
ID
Click the current value to set the ID number (0 ~ 255) for the connected PTZ
camera if necessary.
Make sure the ID setting of the camera is the same as the setting here, or the DVR
will not be able to control the device.
PROTOCOL
Select NORMAL (our protocol), P-D (PELCO-D) or P-P (PELCO-P) protocol.
RATE
Select the baud rate for the connected PTZ camera (2400 / 4800 / 9600 / 19200 /
57600 / 115200).
Make sure the baud rate setting of the camera is the same as the setting here, or
the DVR will not be able to control the device.
manual.
manuals search engine
ADVANCED CONFIG
28
FREQUENTLY-USED FUNCTIONS

PTZ
00
NORMAL
2400