Detection Setting - Avtech avc792pv Bedienungsanleitung

5.5 Detection Setting

Right-click to display the main menu, and select "ADVANCED CONFIG" 
"DETECTION".
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
NOTIFY
1)
2)
Note: The default setting of SS is 03, which means once an object is detected
3)
4)
5)
Downloaded from www.Manualslib.com
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 
LS
SS
TS
MOTION
ALARM
AREA
EXIT
LS (Level of Sensitivity)
"LS" is to set the sensitivity of comparing two different images. The smaller the
value is, the higher sensitivity for motion detection. The highest sensitivity setting is
00, and the lowest sensitivity setting is 15. The default value is 07.
SS (Spatial Sensitivity)
"SS" is to set the sensitivity for detecting the size of one object (the number of the
grids) on the screen. The smaller the value is, the higher sensitivity for motion
detection.
The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The
default setting is 03.
more than 3 grids, the system will get triggered. So the value of SS must be
less than the number of grids that you set up for the motion detection area.
TS (Time of Sensitivity)
"TS" is to set the sensitivity regarding how long one object stays in the detection
area and triggers the recording. The smaller the value is, the higher sensitivity for
motion detection.
The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The
default setting is 02.
MOTION
Select if you want to activate the motion detection function for the selected channel
(ON/OFF).
ALARM
Select N.C./ N.O depending on your installation need. The default alarm value is
OFF.
manuals search engine
ADVANCED CONFIG
27
FREQUENTLY-USED FUNCTIONS

07
03
02
OFF
OFF
EDIT