Camera Connection; Normal Camera Connection - Avtech avc792pv Bedienungsanleitung

Step4: Align the screw hole on the each bracket with the screw hole on the each side of
Step5: Close the upper cover of the DVR, and fasten all the screws you loosened in

2.2 Camera Connection

The cameras must be connected and power-supplied before the DVR is powered on.
Connect the camera with the indicated power supply. Then, connect the camera video
output to the DVR video input port with a coaxial cable or RCA cable with BNC
connectors.
Note: For detailed DVR video input ports, please refer to "1.3 Rear Panel" at page

2.2.1 Normal Camera Connection

Note: For detailed camera installation and connection, please refer to its own user
1) Connecting to DVR video input
2) Connecting to DVR audio input (Optional)
3) Connecting to power
Downloaded from www.Manualslib.com
the hard disk as shown below, and fix the hard disk to the bracket with a hard disk
screw supplied.
Step1.
2.
manual.
Connect the camera video output to the DVR video input port with a coaxial cable or
RCA line with BNC connector.
Connect the camera audio output to the DVR audio input port with a coaxial cable or
RCA cable with BNC connectors.
Connect the camera with indicated power supply and make sure it's power-supplied.
manuals search engine
6
CONNECTION AND SETUP