Ptz Camera Connection - Avtech avc792pv Bedienungsanleitung

2.2.2 PTZ Camera Connection

The following description is taking our brand's PTZ camera as an example.
For DVR setting to control the PTZ camera, please refer to "5.6 PTZ Camera Setting" at
page 28. For detailed PTZ camera control and operation, please refer to its own user
manual.
STEP 1: Get a RJ11 cable with the proper length to your connection.
STEP 2: Remove one end of the insulating coating of the RJ11 cable.
STEP 3: Twist the RS485-A and RS485-B wires of the RJ11 cable and the speed
STEP 4: Connect the other end of the RJ11 cable to DVR.
Downloaded from www.Manualslib.com
RJ11 cable
RS485-A: Red wire
RS485-B: Green wire
The RJ11 cable is not supplied in the sales package.
Different RJ11 connector may have different wire layout, so the connection
might be different. If you cannot control the DVR after connection, please
reverse the RJ11 cable connection with the DVR.
Remove one end of the insulating coating of the RJ11 cable to find the
RS485-A and the RS485-B wires, and remove the insulating coating to reveal
the naked wires for further connection.
dome camera together.
Twist the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the
RS485-A (brown) and RS485-B (orange) wires of the speed dome camera. To
protect the naked wires, use the insulation tape to cover on the twisted wires.
Solder the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the
corresponding pins on the solder side of the optional D-Sub connector.
For DVR PIN configuration, please refer to "APPENDIX 6 PIN
CONFIGURATION" at page 72. For connection details, please check with your
installer.
manuals search engine
7
CONNECTION AND SETUP