Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step3: Close the upper cover of the DVR, and fasten all the screws you loosened in
For 4CH Model
Step1: Loose the screws on the upper cover and remove it from the DVR. Find the hard
Step2: Get a compatible hard disk, and connect it to the power connector and data bus
Step3: Make sure the PCB side is facing up, and place the hard
Downloaded from
www.Manualslib.com
2-2 To install on the second bracket
Connect the power connector and
data bus connector to the HDD.
When connecting the power cable,
make sure the cable is passed
through the power cable of DVD
writer if your DVR is equipped with
a DVD writer. This is to prevent the
HDD power cable from interfering
with the fan spinning.
Align the screw holes of the bracket
with the HDD's screw holes. Make
sure the PCB side of the HDD is
facing up. Then, fasten the HDD to
the bracket.
Step1.
disk bracket located on the DVR base.
connector.
disk between the hard disk bracket on the DVR base as
shown below.
Make sure the other side of the hard disk is
contacted with the DVR base for heat conduction.
manuals search engine
5
CONNECTION AND SETUP
Werbung
Kapitel
