Control Elements En - Abicor Binzel ABI-CAR E-1200 Betriebsanleitung

7 Operation
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Ensure that all required parameters have been set.
7.1 Control elements
1
4
1 Speed display
2 Direction of motion switch
(left/center/right/stop)
Fig. 15 Control elements ABI-CAR E-1200
Pos. Designation
(1) Speed display
(2) Direction of motion left/
center/right/stop switch
(3) Welding mode selection
switch
(4) Speed knob
EN - 22
3 Welding mode selection switch
Function
Display of the welding tractor speed preset on the potentiometer
Selection of desired direction of motion of welding tractor
• Left = move left
• Center = OFF
• Right = move right
Selection of desired welding function
• Down = welding ON
• Center = welding OFF
• Up = end crater filler function (touch function)
Turning the knob for selection of the desired speed of the welding tractor:
• Turn to the right = increase speed
• Turn to the left = decrease speed
ABI-CAR E-1200 / E-1200-O
2
3
4 Speed knob
BAL.0647.0 • 2020-06-05