Abicor Binzel ABI-CAR E-1200 Betriebsanleitung Seite 45

ABI-CAR E-1200 / E-1200-O
1 4
Adjusting screw on cross slide
2 Cross slide 5
3 Hand lever on the horizontal 6
adjuster for torch mount
Fig. 2 Overview of ABI-CAR E-1200 – rear view
A serviced ABI-CAR E-1200-O welding tractor consists of the following components:
1 Pendulum connector
2 Wire feeder connector
3 Power supply connector
4 Operating panel
5 Adjusting screw on cross slide
Fig. 3 Overview of ABI-CAR E-1200-O – front view
BAL.0647.0 • 2020-06-05
Horizontal adjuster for torch mount
Guide rollers made of ceramic
Hexagon socket screw (not shown,
differs from illustration)
6 Hand lever/magnet lifter 10 Adjusting screw to adjust guide arm
7
Magnet 11 Guide arm
12 Horizontal adjuster for torch mount
8 Rubber wheel
9 Eyelet for weight safety device
7 11 Eyelet for weight safety device
Handwheel on torch mount
8 Torch mount 12 Adjusting screw to adjust guide arm
9 Heat shield 13 Operating panel
10 Guide arm 14 Handle
5 Functional description
13 Hand lever on the horizontal
adjuster for torch mount
14 Pendulum
15 Torch mount
16 Handle
EN - 13