Abicor Binzel ABI-CAR E-1200 Betriebsanleitung Seite 49

ABI-CAR E-1200 / E-1200-O
6.1 Preparation
1 Hold the welding tractor by the handle to transport it to the desired work area.
2 Ensure that all buttons and switches on the welding tractor are in the 0 and/or Stop or Off position.
6.2 Connecting to the power supply and wire feeder
1 Connection plug for welding tractor
Fig. 8 Connecting to the power supply and wire feeder (figure is illustrative)
4 Fuse
Fig. 9 Power supply
NOTICE
• The welding tractor is equipped with two supply cables: one connector cable for the tractor wire feeder and one
connector cable for the tractor power supply.
Attach one to the connection plug that corresponds with the power source (not in the scope of supply).
 Fig. 8 Connecting to the power supply and wire feeder (figure is illustrative) on page EN-17
1 Plug the connection plug (1) into the power supply connection (3) and into the connector (5) on the welding tractor.
2 Connect the other connector cable to the control lead connector on the wire feeder.
NOTICE
• Check to see if the power supply matches the specifications in the technical data.
 3.1 Technical data on page EN-9
 Fig. 8 Connecting to the power supply and wire feeder (figure is illustrative) on page EN-17, Fig. 9
3 Insert the power cable (6) with the power supply plug (2) into an outlet.
BAL.0647.0 • 2020-06-05
1 2
2 Power supply plug
6
5 Cable connector for welding tractor
3
3 Power supply
4
5
6 Power cable
6 Commissioning
EN - 17