Abicor Binzel ABI-CAR E-1200 Betriebsanleitung Seite 55

ABI-CAR E-1200 / E-1200-O
1
8
1 Pendulum delay time knob
(right/left/center)
2 Pendulum speed knob
3 Pendulum angle knob
Fig. 16 ABI-CAR E-1200-O control elements
Pos. Designation
(1) Pendulum delay time
knob
(2) Pendulum speed knob
(3) Pendulum angle knob
(4) Speed knob
(5) START/STOP switch
(6) Direction of motion left/
center/right switch
(7) Welding torch reference
point knob
(8) Welding mode selection
switch
BAL.0647.0 • 2020-06-05
2
7
4 Speed knob
5 START/STOP switch
6 Direction of motion switch
(left/center/right)
Function
Select by turning the knob for selecting the desired pendulum delay time in the
corresponding position. Press the knob to change the setting for the
corresponding position:
• L = left
• R = right
• C = center
Select by turning the knob for selection of the desired pendulum speed.
Select by turning the knob for selecting the desired angle at which the pendulum
moves.
Select by turning the knob for selection of the desired speed of the welding
tractor. The selected speed appears in the display above the knob.
• Turn to the right = increase speed
• Turn to the left = decrease speed
Select by switching to the corresponding start/stop position for the welding
tractor and welding process.
Selection of desired direction of motion of welding tractor
• Left = move left
• Center = welding tractor stands still
• Right = move right
Select by turning the knob for setting the reference point for the welding torch.
Selection of desired welding function
• Up = end crater filler function (touch function)
• Center = no welding
• Down = welding
7 Operation
3
4
6 5
7 Welding torch reference point
knob
8 Welding mode selection switch
EN - 23