Pendulum Function (Oscillator) (With Abi-Car E-1200-O Only) En; How The Welding Tractor Moves En - Abicor Binzel ABI-CAR E-1200 Betriebsanleitung

5 Functional description
1 Adjusting screw on cross slide
2 Cross slide
3 Hand lever on the horizontal
adjuster for torch mount
Fig. 4 Overview of ABI-CAR E-1200-O – rear view
5.1 Design
The ABI-CAR E-1200 / E-1200-O welding tractor consists of a housing, a drive with control system, a cross slide, and
a welding torch mount. It is driven by four wheels equally.
The permanent magnet attached inside ensures a solid connection to magnetic surfaces.
The cross slide makes it possible to accurately adjust the position of the welding torch horizontally.
Since the welding power source is directly connected to the welding tractor, the tractor starts the arc as soon as it begins
moving forward.
5.1.1 Pendulum function (oscillator) (with ABI-CAR E-1200-O only)
The pendulum (oscillator) attached to the
to oscillate during operation. Parameters can be configured for this (pendulum speed, angle of the pendulum,
delay time during welding).
5.2 How the welding tractor moves
The welding tractor can be quickly and easily positioned to accommodate the seam to be welded. The welding tractor is
moved by either pressure applied to the guide rollers (5) (Fig. 2) or it is moved along guide rails that can be purchased
separately.
EN - 14
1
13
12
11
10
9
4 Horizontal adjuster for torch
mount
5 Guide rollers made of ceramic
6 Hexagon socket screw (not
shown, differs from illustration)
ABI-CAR E-1200-O welding tractor makes it possible for the welding torch
2
3
5
6
7
8
7 Torch mount 11 Adjusting screw to adjust guide
8 Heat shield
12 Operating panel
9 Guide arm
13 Handle
10 Eyelet for weight safety
device
ABI-CAR E-1200 / E-1200-O
4
arm
BAL.0647.0 • 2020-06-05