Disassembly; Disposal; Packaging - Abicor Binzel ABI-CAR E-1200 Betriebsanleitung

11 Disassembly

11 Disassembly
DANGER
Improper operation can lead to serious injuries that could result in death.
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the control device.
• Switch off the entire welding system.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Consult the documentation for the welding components.
• Observe the information provided in the following section:
 8 Decommissioning on page EN-27
1 Disconnect all cables (power cable and possibly wire feed cable) from the welding tractor.
2 Remove the welding torch neck.

12 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. To correctly
dispose of the product, it must first be disassembled.
 11 Disassembly on page EN-30
12.1 Materials
This product is mainly made of metallic materials that can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
NOTICE
• If the aforementioned material and machine parts are not taken for disposal directly, they should be stored properly. It
is essential to take precautions so that air, water, and the soil are not contaminated.
You can obtain information about disposal and recycling of the aforementioned materials from the following (among others):
German Association for the Waste Disposal, Water and Raw Materials Industry (BDE – Bundesverband der Deutschen
Entsorgungs-, Wasser- und Rohstoffwirtschaft e.V.)
Behrenstrasse 29 / 10117 Berlin Germany / Tel.: 030 590 0335-0 / Fax.: 030 590 0335-99 / Email: info@bde-berlin.de
12.2 Consumables
Oil, greases and cleaning agents may not contaminate the ground or enter the sewage system. These substances must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables' manufacturer.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
EN - 30
ABI-CAR E-1200 / E-1200-O
BAL.0647.0 • 2020-06-05