Adjusting The Cross Slide En - Abicor Binzel ABI-CAR E-1200 Betriebsanleitung

6 Commissioning
6.3 Adjusting the cross slide
NOTICE
• Set the cross slide to match the type and geometry of the welding torch in use.
• The position of the welding torch can be changed vertically (2) and horizontally (6) during the welding process by
adjusting the cross slide.
1
6
1 Screws (2 pcs.)
2 Adjusting screw for vertical position
3 Two bores for adjusting to position 2
Fig. 10 Adjusting the cross slide
1 Loosen the screws (1).
2 Adjust the mount (5).
3 Insert the screws (1) to select the required position (3) or (4) and tighten them.
EN - 18
ABI-CAR E-1200 / E-1200-O
2
4 Two bores for adjusting to position 3
5 Mount
6 Adjusting screw for horizontal position
3
4
5
BAL.0647.0 • 2020-06-05