Mounting The Welding Torch En - Abicor Binzel ABI-CAR E-1200 Betriebsanleitung

ABI-CAR E-1200 / E-1200-O
6.4 Mounting the welding torch
The position of the welding torch can be adjusted during operation.
 Step 1, Fig. 14 Fine adjustment of the cross slide when mounting the welding torch on page EN-21
* Fig. 11 is illustrative. ABI-CAR E-1200 is shown. Discrepancies are possible.
CAUTION
Mechanical damage
Damage to the welding torch due to excessive tightening of the handwheel (3).
• Tighten the handwheel (3) by hand to secure the welding torch.
1 Insert the welding torch (4) into the welding torch fixture and secure it by manually tightening the handwheel (3).
1 Hand lever 1 (adjustment of tilt angle and right-left position)
2 Hand lever 2 (adjustment of tilt angle and right-left position)
Fig. 11 Mounting the welding torch*
2 Set the desired angle (Fig. 12, pos. C) and right-left position (Fig. 12, pos. B) of the welding torch by loosening the hand
lever (1), (2) and manually angling the welding torch. Then tighten the hand lever (1), (2) again.
3 Set the desired angle (Fig. 12, pos. A) of the welding torch to the part to be welded by loosening the hexagon socket
screw (5) and manually turning the welding torch. Then tighten the cylinder head screw (5) again.
BAL.0647.0 • 2020-06-05
3 Handwheel 5 Hexagon socket screw
(not shown, differs from illustration)
4 Welding torch
6 Commissioning
EN - 19