Control Elements/Ports En; Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel xFUME ADVANCED Betriebsanleitung

xFUME ADVANCED
7.1 Control elements/ports
10
9
8
7
1 Service LED
2 Power LED
3 Auto/Manual switch
Fig. 5 Control elements/ports

8 Putting out of operation

 Fig. 5 Control elements/ports on page EN- 13
1 Use the Device On/Off switch (4) on the control panel to switch off the extraction system.
2 Disconnect the extraction system from the power supply.
3 Disconnect the compressed air supply and, if applicable, the current clamp.

9 Maintenance and cleaning

Regular ongoing maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the extraction system.
• Close off the compressed air supply.
• Disconnect all electrical connections.
WARNING
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
WARNING
Risk of crushing
Limbs may be drawn into the device and crushed.
• Keep your hands out of the danger zone.
BAL.0731.0 • 2020-07-14
4 Device On/Off 7
5 Fuse 8
6 Power cable 9
8 Putting out of operation
1
2
3
4
5
6
Hour meter 10 Current clamp port 2
Compressed air connector
Current clamp port 1
EN - 13