Adjusting The Angle Head - Bosch Rexroth ErgoSpin Montageanleitung

3608870DD4/2015-09 | ErgoSpin/CC-ErgoSpin
Assembly
Tab.6: Tightening torque
Size
ESV005 - ESV012
ESV025 - ESV050
ESV073
ESV146
CC-ESV012
ESM025HT
These hand-held nutrunners require that a
suitable output drive be mounted first.
Tools required:
• Hook spanner with DIN 1810 shape B
hinge, outer nut diameter
35-60 mm, pin diameter 4 mm

Fit the output drive onto the nutrunner
body in the desired position.

Screw on the union nut. Ensure that the
union nut will not cant.

Tighten the union nut using a suitable
tool, e.g. a hook spanner.
While doing so, fix the output drive in po-
sition using appropriate means.
Tightening torque
[Nm]
30 + 2
40 + 2
55 + 2
70 + 5
30 + 2
Bosch Rexroth AG
6.2

Adjusting the angle head

There are 24 different positions
which can be taken in 15° incre-
ments.
ESA/ CC-ESA (see Fig. A)
Tools required:
• Hook spanner with DIN 1810 shape B
hinge, outer nut diameter
35-60 mm, pin diameter 4 mm
• Assembly aid ESWM 3 608 876 473

Clamp the assembly aid 20 into a vise or
the like.

Unscrew the union nut 4 using the hook
spanner 21. While doing so, hold the as-
sembly aid 20 to the flange 3 of the angle
head as counterweight.

Remove the angle head 2 and refit it in
the desired position.

Screw on the union nut 4. Ensure that the
union nut will not cant.

Tighten the union nut 4 with the torque
according to Table 7. While doing so,
hold the assembly aid 20 to the flange 3
of the angle head as counterweight.
Tab.7: Tightening torque
Size
ESA005 - ESA030
ESA040 - ESA075
ESA100
ESA150 - ESA220
CC-ESA030S
CC-ESA040S
79/110
Tightening torque
[Nm]
30 + 2
40 + 2
55 + 2
70 + 5
30 + 2
40 + 2