Adjusting The Cutting Angle - Bosch GCM 10 S Professional Originalbetriebsanleitung

OBJ_BUCH-1126-002.book Page 38 Thursday, July 29, 2010 12:07 PM
38 | English
Clamping the Workpiece (see figure H)
To ensure optimum working safety, the work-
piece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
While clamping the workpiece, do not reach
under the clamping lever of the quick-ac-
tion clamp with your fingers.
– Press the workpiece firmly against the
fence 9.
– Insert the quick-action clamp 22 into one of
the holes 29 intended for this purpose.
– Adapt the quick-action clamp to the work-
piece by turning the threaded rod 47.
– Push on the clamping lever 46 in order to
clamp the workpiece.

Adjusting the Cutting Angle

To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use (see "Checking
and Adjusting the Basic Adjustment", page 43).
Always tighten the locking knob 13 firmly
before sawing. Otherwise the saw blade can
become wedged in the workpiece.
Adjusting Horizontal Standard Mitre Angles
(see figure I)
For quick and precise adjustment of commonly
used mitre angles, detents 16 have been provid-
ed for on the saw table:
Left
0°
15°; 22.5°; 15°; 22.5°;
31.6°; 45° 31.6°; 45°; 60°
– Loosen the locking knob 13 in case it is tight-
ened.
– Pull lever 14 and rotate the saw table 17 left
or right to the requested detent.
– Release the lever again. The lever must be
felt to engage in the detent.
1 609 929 X03 | (29/7/10)
Adjusting Any Horizontal Mitre Angle
(see figure J)
The horizontal mitre angle can be set in the
range from 52° (left side) to 62° (right side).
– Loosen the locking knob 13 in case it is tight-
– Pull lever 14 and at the same time push the
– Turn the saw table 17 left or right by the lock-
– Tighten the locking knob 13 again.
Adjusting Standard Vertical Bevel Angles
(see figure K)
For quick and precise adjustment of commonly
used bevel angles, stops are provided for 0°,
45° and 33.9° angles.
– Loosen the clamping lever 32.
– Standard angles 0° and 45°:
– Retighten the clamping lever 32 again.
– Standard angle 33.9°:
Adjusting Any Vertical Bevel Angle
(see figure K)
Right
The vertical bevel angle can be set in the range
from 0° to 45°.
– Loosen the clamping lever 32.
– Tilt the tool arm by the handle 6 until the an-
– Hold the tool arm in this position and retight-
ened.
locking bracket 12 until it engages in the
groove intended for this. The saw table can
be moved freely now.
ing knob until the angle indicator 15 indi-
cates the requested mitre angle.
Tilt the tool arm by the handle 6 to the right
stop (0°) or to the left stop (45°).
Pull adjustment knob 31 completely outward
and turn it by 90°. Now tilt the tool arm via
the handle 6 until the tool arm can be heard
to engage.
gle indicator 48 indicates the desired bevel
angle.
en the clamping lever 32.
Bosch Power Tools