Symbols; Designations - Bosch Rexroth ErgoSpin Montageanleitung

66/110 Bosch Rexroth AG
About this document
Tab.2: Hazard classes as defined in ANSI Z535.6-2006
Warning symbol, signal word
DANGER
WARNING
CAUTION
NOTE

1.3.2 Symbols

The following symbols indicate information
that is not safety-relevant but increases the
understanding of the documentation.
Tab.3: Meaning of the symbols
Symbol Meaning
If this information is disregarded, the
product cannot be used and/or op-
erated to the optimum extent.

Step
ErgoSpin/CC-ErgoSpin | 3608870DD4/2015-09
Meaning
identifies a dangerous situation that will result in
death or serious injuries if it is not avoided.
identifies a dangerous situation that may result in
death or serious injuries if it is not avoided.
identifies a dangerous situation that may result in mi-
nor to moderate injuries if it is not avoided.
Damage to property: The product or the environment
may be damaged.

1.3.3 Designations

This documentation uses the following desig-
nations:
Tab.4: Designations
Designation Meaning
BS Bediensystem (operating sys-
tem): Operating program of
the tightening system
CS351E... Compact System
ErgoSpin (compact system
351 ErgoSpin): Single-chan-
nel tightening system for
ErgoSpin and CC-ErgoSpin
CC-CS351E-D Single-channel tightening
system for CC-ErgoSpin
CC-ErgoSpin Current Control (current con-
trol): Current-controlled
ErgoSpin handheld nutrunner
ESA ErgoSpin right-angle nutrun-
ner: ErgoSpin right-angle nut-
runner
CC-ESA Current-controlled ErgoSpin
right-angle nutrunner
ESM ErgoSpin Mittelgriffschrau-
ber: ErgoSpin pistol grip nut-
runner
351