3608870DD4/2015-09 | ErgoSpin/CC-ErgoSpin
Disassembly and replacement
11
Disassembly and re-
placement
CAUTION
The product is not protected against
incorrect assembly/disassembly!
Risk of injury and damage to the device
during subsequent operation.
Assemble/disassemble the product
according to the following information
and in the correct order.
Only qualified personnel are autho-
rized to assemble/disassemble the
product.
Do not clamp the hand-held nutrunner
in a vise or similar.
Pull the plug out of the socket before
assembling/disassembling accesso-
ries.
Bosch Rexroth AG
CAUTION
Improper handling!
In unfavorable conditions, handling or as-
sembling/disassembling certain parts and
components in an unsuitable manner can
cause injuries. Injury due to crushing,
shearing, cutting, impact!
Observe the general construction and
safety regulations for handling and as-
sembly/disassembly.
Use suitable assembly/disassembly
and transport equipment.
Prevent trapping and crushing injuries
by using suitable precautions.
Only use suitable tools.
Use special tools if such are speci-
fied.
Use tools appropriately.
If necessary, use suitable protective
equipment (e.g. protective goggles,
safety shoes, protective gloves).
Do not stand under suspended loads.
Lay cables and lines in accordance
with the permissible bending radiuses
so that they cannot be damaged and
no one can trip over them.
To disassemble the hand-held nutrunner,
take the following individual steps:
Disconnecting the ErgoSpin connecting
cable
Disassembling the output drive
89/110