Parameter Adjustment - Bosch Servodyn-ASC Betriebshandbuch

Servodyn - ASC

Parameter Adjustment

Output Condition
OUT D1
GB
Output Condition
OUT D2
GB - 42
Parameter CP.21 determines the output condition of the digital output
D1 (terminal X2.8) . ! see table below !
Adjustment Range:
Resolution:
Factory setting:
Parameter CP.22 determines the output condition of the digital output
D2 (terminal X2.9). ! see table below !
Adjustment Range:
Resolution:
Factory setting:
Value D1 and D2 Switching conditions
0 always inaktiv
1 always aktiv
2 ready for operation; no malfunction (operating state: ready)
3 ready for operation;control relaise (terminal X2.1) given;
modulation enabled (operating state: run)
4 abnormal operating state or error (status A.xx or E.xx)
5 error (only status E.xx)
6 - reserved -
7 after the motor positive temperature coefficient is triggered
8 after the motor positive temperature coefficient is triggered
9 current controller restricted
10 speed controller restricted
11 any controller restricted
12 drive accelerates
13 drive decelerates
14 drive runs with constant speed
15 drive runs with constant speed > speed 0
16 forward – not with noP, LS, Abnormal Stopping or error
17 reverse – not with noP, LS, Abnormal Stopping or error
only digital output D1
18 - reserved -
19 - reserved -
20 torque > torque level
21
22
23
24 overload prewarning: overload counter > 80 %
25 overload prewarning: overload counter > 40 %
26 prewarning: "heat sink temperature "
27 - reserved -
28 - reserved -
1)
Only during closed loop operation (CP.32 = 1) !
Hysteresis
of the torque level
of the speed level
0 ... 28
1
20
0 ... 28
1
18
only digital output D2
actual speed> speed level
- reserved -
1)
- reserved -
- reserved -
- reserved -
- reserved -
speed ref. displ.> speed level
system deviation > speed level
: 5% of M motor adjusted in the factory
N
(see page GB 48)
: 10 rpm
1070066022 - 101
1)