Bosch Servodyn-ASC Betriebshandbuch Seite 96

A
b
n
o
r
m
a
l
S
t
o
p
p
i
n
g
Apparent Motor Current
Max. Apparent Motor Current
Actual Torque Display
1070066022 - 101
Base-Block – The Base-Block-Time (motor suppression time)
Time runs out. The power transistors are locked.
external – The external fault is triggered (terminal X2.7).
fault The drive's response to external errors is
adjusted in parameter CP.15.
Prohibited – Rotation release on terminal X2.3 is missing:
rotation Drive does not start with positive setpoint and/or
forward decelerates until standstill.
See also parameter CP.35
Prohibited – Rotation release on terminal X2.4 missing:
rotation Drive does not start with negative setpoint and/
reverse or decelerates until standstill.
See also parameter CP.35
Displays the actual apparent current in ampere.
Resolution: 0,1 A
max. tolerance: approx. ±10 %
Displays the maximum apparent motor current, which is measured
during operation. The display is in ampere.
During operation, using UP ( ) or DOWN ( ) you can reset the peak
value. The peak value is deleted when the unit is POWER OFF.
Resolution: 0,1 A
max. tolerance: approx. ±10 %
Displays the actual torque in newtonmeter.
Resolution: 0,1 Nm
max. tolerance: approx. ±20 % in base speed range
(in the field weakening range larger tolerances are possible)
During open-loop operation (CP.32 = 0) value 0 is always shown.
Servodyn - ASC
Operating Display Operating Display Operating Display
Operating Display Operating Display
GB - 31
GB