Bosch Servodyn-ASC Betriebshandbuch Seite 102

Behaviour at External Fault
1070066022 - 101
This parameter determines how the drive reacts to an external error
(digital Input I3).
Adjustment Range:
Resolution:
Factory setting:
Note: ENTER-Parameter
Value Error / Status
massage
0 E.EF
1 A.EF
2 A.EF
3 A.EF
4 A.EF
5 A.EF
6 none
Quick stop
Servodyn - ASC
P P P P P arameter Adjustment arameter Adjustment arameter Adjustment arameter Adjustment
arameter Adjustment
0...6
1
0
Response of the drive
modulation immediately switched off
! To restart remove error and activate
Reset !
quick stop / modulation switched off after
speed 0 is reached
! To restart remove error and activate
Reset !
quick stop / holding tourqe at speed 0
! To restart remove error and activate
Reset !
modulation immediately switched off
! Automatic restart, when error is no
longer present !
quick stop / modulation switched off after
speed 0 is reached
! Automatic restart, when error is no
longer present !
quick stop / holding tourqe at speed 0
! Automatic restart, when error is no
longer present !
no effect on the drive
! Fault is ignored !
⇒ ⇒ ⇒ ⇒ ⇒
deceleration at the torque limit
(CP.9)
GB
GB - 37