Spare Parts - sematic DRIVE SYSTEM Bedienungsanleitung

11 CONTROLLER SOFTWARE UPGRADE
• Connect the handset to the RJ45 connector
• If necessary, using keys
"OK" key or confirm the suggested language with "OK"
• Using keys and
• Press "OK" to confirm the choice
• Display shows the last available update and the software version in use at the moment.
• Press "OK" to confirm the software update
• Controller operates a reset and the display shows "Upload" with the progression value of
data loading
• At the end of the upload the controller operates a reset
• It is anyway advisable to run a new SELFLEARNING CYCLE and to check the parameter
settings
In case of interruption of connection between handset and controller during the data
transfer, turn "OFF" the controller, turn it "ON" again and reconnect the handset.
The upload starts again from the beginning
12 DOOR OPERATOR MAINTENANCE
At least once a year complete the following checks:
• Clean the doors (tracks, bottom tracks, belts etc.) from dust or debris as this maintains
the door good mechanical operation
• Check the electric connections and their fitting to the connectors
• Check that the door operator toothed belt is tight enough and in good working condition
• Check and clean the cable connections of the motor and of the motor Encoder

13 SPARE PARTS

It is possible to order all the Sematic Drive System
logue, by specifying the required quantity and the code of the ordered piece.
The spare parts manual is extremely important to avoid misunderstandings and to ensu-
re a rapid supply of the correct spare parts. The spare parts catalogue, with photographs
and details will make the Sematic doors spare parts purchase easy and quick.
w w w . s e m a t i c . c o m
and choose the required language and confirm with the
, run through the MAIN MENU and choose "UPGRADE"
38
spare parts using the spare parts cata-
©
© SEMATIC
infosem@sematic.com Changes can be made without notice
see www.sematic.com for latest release
All rights reserved