Commissioning; Configuration Of The Instrument - WIKA CPH6300 Betriebsanleitung

5. Commissioning, operation

5.2 Commissioning

1. Connect sensor and switch the instrument on with the [ON/OFF] button.
⇒
Following the segment test, the display displays short information about its
configuration:
rate sLo
rate FASt
rate P.det
The instrument is then ready for measurement.

5.3 Configuration of the instrument

1. To configure, press the [SET/MENU] button for 2 seconds.
⇒
The menu (main display
2. With the [SET/MENU] button, select the required menu branch.
3. Select the parameter with the [▶] button.
4. Change the parameter with the [▲] or [▼] buttons.
5. Step the parameter forward using the [▶] button.
6. Press the [SET/MENU] button.
⇒
Changes back to the main menu and saves the settings.
7. With [STORE/QUIT], the configuration is concluded.
WIKA operating instructions, model CPH6300
Downloaded from www.Manualslib.com
Standard measurement is set.
Fast measurement is set.
Peak value detection is set.
The availability of some of the menu items is dependant on the current
instrument settings (e.g. a few menu items will be locked, if the logger
contains data).
SEt
If the [SET/MENU] and [STORE/QUIT] buttons are pressed, together for
longer than 2 seconds, the factory settings will be restored.
Data in the individual value logger (logger:
the initial menu read Lo66
If no button is pressed within 2 minutes, the configuration of the instrument
will be interrupted. Changes made up until that point will not be saved!
manuals search engine
) is called up.
Fvnc Stor
: also see chapter 5.5 "Data logger".
EN
) is displayed as
13