WIKA CPH6300 Betriebsanleitung Seite 19

5. Commissioning, operation
Menu
"MENU"
SET
Lo66
SET
CLOC
read
Lo66
1) Menu cannot be selected if there is data in the logger memory. If this is to be changed, the data must first be deleted (see chapter
5.5 "Data logger").
2) This menu can only be selected if an appropriate sensor is connected to connection 1. When using a second corresponding
sensor on connection 2 then the settings are adopted.
3) Only for 2-channel version
WIKA operating instructions, model CPH6300
Downloaded from www.Manualslib.com
Parameters
Values
▶ ▲ or ▼
-19999...
AL.Lo
AL.DIF-Hi
DIF
Sensor-Min ...
AL.Hi
AL.DIF-Lo...
AL.Hi
19999
DIF
AL.Lo ...
Sensor-Max
Set Logger: Logger function configuration
Selection of the logger function
CYCL
Fvnc
Stor
oFF
00:01 ... 60:00
CYCL
on/oFF
Lo.Po
Set Clock: Setting of the real-time clock
HH:MM
CLOC
YYYY
YEAr
TT.MM
date
rEAd Logg: Reading the individual logger data
manuals search engine
Meaning
Min alarm limit difference (not if AL.diff = oFF)
Min alarm limit sensor (not if AL. = oFF) Sensor-
Min is the lower scale range limit of the sensor.
Max alarm limit difference (not if AL.diff = oFF)
Max alarm limit sensor (not if AL. = oFF) Sensor-
Max is
Cyclic: Logger function "cyclic logger"
Store: Logger function "individual value logger"
No logger function
Cycle time for cyclic logger [minutes:seconds]
Low-power logger with very low power supply
(only if cyclic logger with slow measuring rate)
Clock: Set time hours:minutes
Year: Set year
Date: Set time day.month
See chapter 5.5.1 "Manual records"
3)
EN
3)
1)
1)
1)
1)
19