WIKA CPH6300 Betriebsanleitung Seite 16

5. Commissioning, operation
Menu Parameters
"MENU"
EN
UNiT
A
t
P.abs
dp
strt
Set output: Settings for universal output
SET
Out
Out
adr.
DAC
1) Menu cannot be selected if there is data in the logger memory. If this is to be changed, the data must first be deleted (see chapter
5.5 "Data logger").
2) This menu can only be selected if an appropriate sensor is connected to connection 1. When using a second corresponding
sensor on connection 2 then the settings are adopted.
3) Only for 2-channel version
16
Downloaded from www.Manualslib.com
Values
▶ ▲ or ▼
"SPEd" or "FLo": Settings
SPEd: Airspeed unit
n:S
kn:h
nPh
knot
FLo: Volume flow or flow unit
n3:s
n3:n
n3:h
L:S
L:n
FLo: Flow /Volume flow - display - cross-section
10.0 ... 1999.9,
2000 ... 14000
-100.0 ...
1000.0 °C
100.0 ...
1999.9 mbar
0000, 000.0,
00.00
oFF, 1 ... 1000
oFF
SEr
dAC
01.11 ... 91
CH 1, CH 2 or
DIF CH
manuals search engine
Meaning
Metres per second, m/s
Kilometres per hour, km/h
Miles per hour, mph
knots
Cubic metres per second, m³/s
Cubic metres per minute, m³/min
Cubic metres per hour, m³/s
Litres per second, l/s
Litres per minute, l/min
Effective area of the channel in cm²
Air flow temperature
Ambient pressure
Decimal point setting
Minimum display, below which display 0 is forced.
Interface and analogue output deactivated
Serial interface activated
Analogue output activated
Base address of the instrument for serial
communication (only with Out = SEr).
Measuring input which should be used for the
analogue output (if Out = DAC).
WIKA operating instructions, model CPH6300
3)