WIKA CPH6300 Betriebsanleitung Seite 25

5. Commissioning, operation
Time and date
■
Lo66 FULL
(2-channel version)
Sensor 1: Measured value
■
Sensor 1: Min.-Peak, Max.-Peak since last save
■
Sensor 2: Measured value
■
Sensor 2: Min.-Peak, Max.-Peak since last save
■
Difference sensor 1 - sensor 2: Measured value
■
CALC off
■
CALC
■
change of pressure (only for sensor connection 1)")
Time and date
■
Lo66 FULL
5.5.1.2 Requesting manual recording
Saved data sets can be read with GSOFT software and also be viewed in the instrument
display.
1. Press the [SET/MENU] button for 2 seconds.
⇒
The display will then show
2. Press the [▶] button briefly.
⇒
Changing between measured values and display date and time for the data set.
3. Press the [▲] or [▼] button.
⇒
Changes between the data sets.
4. Press [STORE/QUIT] button.
⇒
Finish the display of the recordings.
WIKA operating instructions, model CPH6300
Downloaded from www.Manualslib.com
Shows in the event the logger memory is full.
: Difference sensor 1 - sensor - 2: Min.-Peak, Max.-Peak since last save
"active": Estimated calculation and dummy values (see chapter 5.4.5 "Rate of
Shows in the event the logger memory is full.
With the single-value logger, after saving a measured value, the pressure
sensor can no longer be changed, otherwise invalid data could be read.
To read the data, the pressure sensor used must be connected!
read Lo66 is displayed only if data sets have already been saved!
Without any data sets, the
manuals search engine
read Lo66 .
SET CoNF configuration menu is displayed.
EN
25