Manual Records - WIKA CPH6300 Betriebsanleitung

5. Commissioning, operation
2-channel version:
The data logger displays 9 measuring results for each data set:
■
Measured or mean value (depending on function), Min.-Peak and Max.-Peak sensor 1
■
Measured or mean value (depending on function), Min.-Peak and Max.-Peak sensor 2
■
EN
Measured or mean value (depending on function)
■
- CALC off
- CALC
change of pressure (only for sensor connection 1)")
Min.- and Max.-Peak are, respectively, the minimum and the maximum measured value
during the last save operation. Therefore both the current pressure value and also any
pressure spikes occurring can be accurately analysed.
To evaluate the data, you will need GSOFT software (from V3.0), where the logger
function can be very easily started and set.
Free-of-charge updates are available at www.wika.com.
With the logger function
not available - the [STORE/QUIT] button is then responsible for the logger operation.

5.5.1 Manual records

5.5.1.1 Start manual recording
If the logger function,
instrument"), a maximum of 1,000 measurements can be stored manually:
1. Press [STORE/QUIT] button.
⇒
Data set is stored ("St. XX" is displayed briefly. XX is the number of the data set)
2. Measuring point input "
⇒
Selection of the measuring location via the [▲] or [▼] buttons. Number from
0 ... 19999 or text, which is assigned a number from 1 ... 40.
⇒
Assignment of the text is made via the "ConfigSoft" software which is available free
of charge from www.wika.com.
3. Confirm the entry with [STORE/QUIT].
At the moment of saving, a data set consists of the following values.
(1-channel version)
Measured value
■
CALC off
■
CALC
■
change of pressure (only for sensor connection 1)")
24
Downloaded from www.Manualslib.com
: Min.-Peak and Max.-Peak sensor 1 – sensor 2
"active": Estimated calculations and dummy values (see chapter 5.4.5 "Rate of
Fvnc Strt
Fvnc Stor
L-Id ":
: Min.-Peak and Max.-Peak since last save
"active": Estimated calculation and dummy values (see chapter 5.4.5 "Rate of
manuals search engine
Fvnc CYCL
or activated, the hold function is
is selected (see 5.3 "Configuration of the
WIKA operating instructions, model CPH6300