WIKA CPH6300 Betriebsanleitung Seite 14

5. Commissioning, operation
Menu Parameters
"MENU"
Set configuration: Generic settings
SEt
EN
ConF
UNiT
base
dP
FaCT
SL
ALT
rate
t.AU6
1) Menu cannot be selected if there is data in the logger memory. If this is to be changed, the data must first be deleted (see chapter
5.5 "Data logger").
2) This menu can only be selected if an appropriate sensor is connected to connection 1. When using a second corresponding
sensor on connection 2 then the settings are adopted.
3) Only for 2-channel version
14
Downloaded from www.Manualslib.com
Values
▶ ▲ or ▼
Unit: Selection of the measuring unit
Cursor at bar,
mbar, ...
Cursor at "user" The measured value is specified in the freely
bar, mbar
0000, 000.0 ...
.0000
-19999 ...
19999
Sea level: Correction of the sea level
oFF
on
-2000 ... 9999
Rate: Measuring rate
Slo
FASt
P.dEt
Averaging
1 ... 120
oFF
manuals search engine
Meaning
Measured values are denoted in the
corresponding unit; the units selectable are
dependent on the sensors.
configurable user unit: Linear calculation
Unit "user": Base unit
Unit "user": Decimal point of the multiplication
factor
Unit "user": Multiplication factor
Sea level correction off
Sea level correction on
(see chapter 5.4.3 "Sea level correction for
absolute pressure sensors").
Sea level correction in [m] (only when sensor
1 SL = on)
Slow: Slow measuring rate (4 Hz filtered, low
power consumption)
Fast: Fast measuring rate, filtered (> 1,000 Hz)
Peak detection: Fast measuring rate, unfiltered
(1,000 Hz)
Averaging interval in seconds, used by the
averaging function off.
Averaging deactivated
WIKA operating instructions, model CPH6300
1) 2)
1) 2)
1)
1)