Transport, Packaging And Storage; Transport; Packaging And Storage - WIKA CPH6300 Betriebsanleitung

3. Safety / 4. Transport, packaging and storage
EN

4. Transport, packaging and storage

4.1 Transport

Check the model CPH6300 hand-held pressure indicator and the model CPT6200
reference pressure sensor for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
If the instrument is transported from a cold into a warm environment, the formation of
condensation may result in instrument malfunction. Before putting it back into operation,
wait for the instrument temperature and the room temperature to equalise.

4.2 Packaging and storage

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in
installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature: -25 ... +70 °C (-13 ... +158 °F)
■
Humidity: 0 ... 95 % relative humidity (non-condensing)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Hazardous environments, flammable atmospheres
■
10
Downloaded from www.Manualslib.com
This marking on the instruments indicates that they must not be disposed of
in domestic waste. The disposal is carried out by return to the manufacturer
or by the corresponding municipal authorities.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property can occur.
▶
When unloading packed goods upon delivery as well as during internal
transport, proceed carefully and observe the symbols on the packaging.
▶
With internal transport, observe the instructions in chapter 4.2 "Packaging
and storage".
manuals search engine
WIKA operating instructions, model CPH6300