Ottobock 5A60-Varos Gebrauchsanweisung Seite 33

10. Magnetic cap, threaded version, art. no.
5E10=M
11. Magnetic bottom shell, art. no. 5E5=M
6.2 Fabricating the check socket
Parts required
• 2 pc. medial socket shell (size M), art. no.
5E15=L-M
• 2 pc. medial socket shell (size M), art. no.
5E15=R-M
• 2 pc. lateral socket shell (size M), art. no.
5E16=L-M
Contains: 2 pc. riveted Boa housings, 2
pc. Boa dials, 2 pc. Boa reels
• 2 pc. lateral socket shell (size M), art. no.
5E16=R-M
Contains: 2 pc. riveted Boa housings, 2
pc. Boa dials, 2 pc. Boa reels
• 2 pc. socket brim pad (size M), art. no.
5E17=L-M
• 2 pc. socket brim pad (size M), art. no.
5E17=R-M
• 4 pc. fabric adhesive strip set (size M), art.
no. 5E7=M
• 4 pc. Boa cable 2.5 m, art. no. 5E12
Check socket alignment
CAUTION
Reduced strength of the check socket
Falling due to breakage of load-bearing components.
► When a check socket is combined with a longer side rail assembly and shorter shell
assembly, it may only be used subject to complying with safety measures, e.g. walking
between parallel bars.
INFORMATION
For the alignment of the check socket with a desired socket length, the longest possible shell
assembly and longest possible side rail assembly always have to be used.
The check socket is fabricated with the components named above, similar to the fabrication of the
definitive socket.
► Follow the steps in the sections "Routing the cables" up to and including "Screwing the bot­
tom plate to the connection adapter".
Inserting the liner
A liner from a previous fitting or the 6Y200=* Varos liner may be used.
To use a 6Y200=* Varos liner, observe the steps in the 647G1239 instructions for use.
INFORMATION: The Varos liner trimmed for the check socket cannot be reused.
Complete the following steps to insert the liner (from a previous fitting):
12. Shell assembly right 240 mm
13. Shell assembly right 200 mm
• 5 pc. medial side rail (size M), art. no.
5E1=M
• 5 pc. lateral side rail, straight (size M), art.
no. 5E2=M
• 5 pc. axle (size M), art. no. 5E4=M
• 1 pc. connection adapter (size M), art. no.
5E6=M
• 1 pc. magnetic bottom shell (size M), art.
no. 5E5=M
• Connection adapter screw set (size M), art.
no. 5E18=S-M
Contains: 6 pc. M6x10 cap screws
• 1 pc. clamping piece set (size M), art. no.
5E8=M
Contains: 3 pc. clamping pieces, 7 pc. slot
nuts, 7 pc. M4x8 countersunk head screws
• 1 pc. magnetic cap, threaded version (size
M), art. no. 5E10=M
Contains: magnetic cap and M10 counter­
sunk head screw
33