Information On The Power Supply/Battery Charging - Ottobock Kenevo 3C60 Gebrauchsanweisung

► If water, salt water or body and/or wound fluid has penetrated the product and components,
the Protective Cover (if any) must be removed immediately. Dry the knee joint and compon­
ents with a lint-free cloth and allow the components to fully air dry. The prosthesis must be
inspected by an authorised Ottobock Service Centre. The O&P professional is your contact
person.
CAUTION
Signs of wear to the product components
Falling due to damage or malfunction of the product.
► In the interest of your own safety and in order to maintain operating reliability and protect the
warranty, the service intervals must be observed.
NOTICE
Improper product care
Damage to the product due to the use of incorrect cleaning agents.
► Clean the product with a damp cloth only (fresh water).
INFORMATION
Knee joint movement noise
When using exoprosthetic knee joints, servomotor, hydraulic, pneumatic or brake load depend­
ent control functions can cause movement noise. This kind of noise is normal and unavoidable.
It generally does not indicate any problems. If movement noise increases noticeably during the
lifecycle of the knee joint, the knee joint should be inspected by an O&P professional immedi­
ately.

4.4 Information on the Power Supply/Battery Charging

CAUTION
Charging the prosthesis without taking it off
Falling due to unexpected behaviour of the prosthesis because of changed damping behaviour.
► For safety reasons, wearing the prosthesis is not permitted during the entire charging pro­
cess.
NOTICE
Use of incorrect power supply unit/battery charger
Damage to product due to incorrect voltage, current or polarity.
► Use only power supply units/battery chargers approved for this product by Ottobock (see
instructions for use and catalogues).
CAUTION
Charging the product with damaged power supply unit/charger/charger cable
Falling due to unexpected behaviour of the product caused by insufficient charging.
► Check the power supply unit, charger and charger cable for damage before use.
Replace any damaged power supply unit, charger or charger cable.
►
41