Error while charging the product
LED
LED
Battery char
on
on
ger connected
power
bat
to product
sup
tery
ply
char
ger
No
Yes
Beep signal
4 x short at intervals
of approx. 20 sec.
(continuously)
13.2.3 Status signals
Battery charger connected
LED on
LED on
power
battery
supply
charger
Battery charger disconnected
Beep
Vibration
signal
signal
1 x short
1 x short
Error
Country-specific plug
adapter not fully engaged on
power supply
Non-functional socket
Defective power supply
Distance between battery
charger and receiver of the
charging unit too big
No connection between bat
tery charger and power sup
ply
Defective battery charger
Error
Charging the battery outside the
allowable temperature range
Event
When connecting the power supply to the outlet, the LED on the battery
charger lights up briefly
Power supply and battery charger operational
Event
Self-test completed successfully. Product is operational.
Resolution
Check whether the country-
specific plug adapter is fully
engaged on the power sup
ply.
Check socket with another
electric device.
The charger and the power
supply must be inspected by
a prosthetist.
The distance between the
battery charger and the
receiver on the product must
not exceed 1 mm / 0.04 inch
Check whether the charging
cable plug is fully engaged
on the battery charger.
The charger and the power
supply must be inspected by
a prosthetist.
Resolution
Check whether the specified ambi
ent conditions for charging the bat
tery are met (see Page 58).
63