Stryker Prime TC 1460 Bedienungsanleitung Seite 15

T T r r a a n n s s f f e e r r r r i i n n g g a a n n o o c c c c u u p p a a n n t t
W W A A R R N N I I N N G G
• Always apply the brake when an occupant is getting in the product or out of the product to avoid instability.
• Do not overload the product above the safe working load of 500 lb (226.8 kg).
• Do not allow the occupant to lean outside of the perimeter of the product to avoid tipping.
C C A A U U T T I I O O N N
• Always apply the brake to prevent unintended movement.
• Do not place car seats, infant carriers, or other objects on the product seat or on the occupant's lap.
• Always keep occupant extremities and operator extremities away from the flip-up armrest when raising or lowering the
armrest to avoid the risk of pinching.
• Do not hang items on the push handles, chart holder, optional oxygen bottle holder, or flip-up armrests to avoid
instability.
• Always clear the path of the swing-away footrests before activation to avoid entrapment.
• Do not sit, stand, or lean on the flip-up armrests, footrest, leg rest, or seat back to avoid instability.
• Do not use the flip-up armrests, chart holder, optional oxygen bottle holder, or the optional IV pole as a push or pull
device.
Only use P P r r i i m m e e T T C C for single occupants who have the ability to hold themselves in an upright, seated position, unassisted,
and in compliance with facility guidelines for transporting occupants.
To transfer an occupant (see Stowing the flip-up footrest (page 13)):
N N o o t t e e - - Keep the footrest in the stowed position when there is no occupant in P P r r i i m m e e T T C C . .
1. Position the chair near the occupant.
2. Push down on the brake pedal to apply the brake. Push on the product to make sure that the brake is working.
3. Assist the occupant in getting into P P r r i i m m e e T T C C . Make sure that the occupant is seated in an upright position against the
seat back.
4. Using your foot, lower the flip-up footrest to the transport position by lifting up on the footrest lever (A) (Figure 4).
5. Position the occupant's feet fully on the footrests.
6. Put the flip-up armrests down and make sure that the occupant's arms are fully positioned on the armrests.
R R e e m m o o v v i i n n g g a a n n o o c c c c u u p p a a n n t t
W W A A R R N N I I N N G G
• Always apply the brake when an occupant is getting in the product or out of the product to avoid instability.
• Do not allow the occupant to lean outside of the perimeter of the product to avoid tipping.
1460-109-005 Rev C.0
F F i i g g u u r r e e 4 4 – – F F l l i i p p - - u u p p f f o o o o t t r r e e s s t t l l e e v v e e r r
A
11 EN