Stryker Prime TC 1460 Bedienungsanleitung Seite 31

C C l l e e a a n n i i n n g g
C C A A U U T T I I O O N N
• Do not steam clean the product.
• Always make sure that all labels are intact, brake pedal and go pedal lock properly in both positions, and check all
components for proper lubrication before you return the product to service after cleaning.
• Always make sure that you wipe each product with clean water and thoroughly dry each product after cleaning. Some
cleaning products are corrosive in nature and may cause damage to the product if you use them improperly. If you do
not properly rinse and dry the product, a corrosive residue may be left on the surface of the product that could cause
premature corrosion of critical components. Failure to follow these cleaning instructions may void your warranty.
N N o o t t e e
• Direct skin contact with visibly soiled, permeable material may increase the risk of infection.
• Do not power wash the padded seat option. If the product is equipped with the padded seat option, remove the padded
seat before power washing.
These instructions are intended to provide recommended cleaning methods for Model 1460 P P r r i i m m e e T T C C .
P P r r i i m m e e T T C C is power washable. The product may show some signs of oxidation or discoloration from continuous washing.
However, no degradation of the product's performance characteristics or functionality will occur due to power washing as
long as the proper procedures are followed.
Recommended cleaning method
To wipe down the product with disinfectant between uses, follow these steps:
1. Follow the cleaning solution manufacturer's dilution recommendations exactly.
2. Hand-wash all surfaces of the product with a recommended disinfectant between uses.
3. Apply the recommended disinfectant solution by spray or pre-soaked wipes.
4. Make sure that you disinfect all surfaces. Pay attention to high contact areas, such as the flip-up armrest, seat, seat
back, push handles, and oxygen bottle holder option.
5. Follow the cleaning solution manufacturer's instructions for appropriate contact time and rinsing requirements.
6. Dry thoroughly before you return the product to service.
Recommended cleaners
Quaternary cleaners (active ingredient - ammonium chloride) that contain less than 3% glycol ether
Phenolic cleaners (active ingredient - o-phenylphenol)
Chlorinated bleach solution (5.25% bleach diluted 1 part bleach to 100 parts water which equals 520 ppm available
chlorine (40 mL of a 5.25% bleach solution per 4000 mL water))
21% isopropyl alcohol
Avoid over saturation and make sure that the product does not stay wet longer than recommended by the cleaning solution
manufacturer's guidelines for proper disinfecting.
1460-109-005 Rev C.0 27 EN