Troubleshooting - Circadiance SmartMonitor2 Bedienungsanleitung

Whenever a technical problem occurs which you cannot handle, contact your dealer. Do not try to fix the SmartMonitor 2.
Following are some common problems.
Problem Possible Cause
Monitor will not Monitor disconnected from
Operate power cord/battery charger,
batteries discharged.
No Power at outlet.
Defective power cord/battery
charger.
Internal part failure.
All lights will flash Internal error condition
together and the detected by SmartMonitor 2.
alarm will beep in
unison with the
flashing lights.
Pressing RESET will
not silence alarm.
Instructions
Plug power cord/battery charger into monitor and outlet.
Locate an outlet with power.
Contact your dealer.
Contact your dealer.
Reduce likelihood of electrostatic discharge around
SmartMonitor 2. Contact your dealer.
If an Error number is displayed on the LCD (the LCD is
located on the bottom of the monitor), record this information.
Contact your dealer.
If there is an internal software error, a special power off
procedure is required.
•
Press and hold the RESET button, while still holding down
the RESET button press and hold the POWER button.
Hold both buttons down for 5 seconds.
•
Release POWER button and continue to hold the RESET
button until the monitor turns off.

Troubleshooting

Troubleshooting
51