Industry Canada Cs-03 Notice; Fcc Part 15 - Circadiance SmartMonitor2 Bedienungsanleitung

How Does the SmartMonitor 2 work?

Industry Canada CS-03 Notice

NOTICE: The Industry Canada (IC) label on the SmartMonitor 2 identifies certified equipment. This certification means that
the equipment meets certain telecommunications network protective, operational, and safety requirements as prescribed in
the appropriate Terminal Equipment Technical requirements document (s). The Department does not guarantee the
equipment will operate to the user's satisfaction.
Before installing the SmartMonitor 2, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions might not prevent degradation of service in some
situations.
The Circadiance Service Center should coordinate repairs to certified equipment at 1-888-825-9640. Any repairs or
alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company
cause to request the user to disconnect the equipment.
Users should ensure, for their own protection, that the electrical ground connections of the power utility, telephone lines, and
internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural
areas.
Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.
The Ringer Equivalent Number (REN) assigned to the SmartMonitor 2 provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface. The termination of an interface may consist of any combination of
devices subject only to the requirements that the sum of Ringer Equivalent Numbers of all the devices does not exceed five
(5.0).

FCC Part 15

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, following part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
12