Portable Operation Of The Smartmonitor 2; Charging The Smartmonitor 2 Battery - Circadiance SmartMonitor2 Bedienungsanleitung

Portable Operation of the SmartMonitor 2

The SmartMonitor 2 is designed for portable use. When the power cord is not used, the monitor relies on the previously
charged internal battery for power.
Circadiance recommends that the SmartMonitor 2 be used with the power cord/battery charger whenever possible.
However, when the monitor is used without the power cord/battery charger the SmartMonitor 2 is fully functional. All alarms
are operational. With a fully charged battery, the monitor will run for 15 hours. The amount of time to completely recharge a
fully depleted battery is 6 hours.

Charging the SmartMonitor 2 Battery

As a rule, a fully charged battery can operate for 15 hours. This may vary, however, depending on the level of use, number of
alarms, and other factors. When the low battery light comes on, you should recharge the battery immediately. A fully drained
battery should be recharged for 6 hours. When you need to recharge the SmartMonitor 2 battery, follow the steps below.
•
Connect the power cord/battery charger to the back panel of
the SmartMonitor 2.
•
Plug the power cord/battery charger into a power outlet. The
green charger light comes on.
•
If the SmartMonitor 2 is turned on, the yellow low battery light
blinks until the minimum charge level is reached. Then, the
yellow light goes off.
Fully drained batteries need about 6 hours to recharge.
Unit should be at room temperature 65°F to 85°F while
charging or batteries may not reach a full charge. Only use
Circadiance batteries.
The Power Cord Connector must be plugged into the
SmartMonitor 2 DC Power Input as shown in the illustration to the
right. The Power Cord Connector can only be inserted as shown.
Portable Operation of the SmartMonitor 2
39